Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

problem in S11 plot in CST

Status
Not open for further replies.
A

alaalemaryeen

Newbie level 3
Joined
May 30, 2014
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
17
Hello,

I'm designing a monopole antenna in CST using SMA connector for feeding. The problem is with the results at 2 GHz, I've tried many settings but I'm getting the same results, any suggestion would be helpful!

Thanks
Capture.PNG,
 

Oh, now that's interesting! How did you do that? :)
Post your project file or at least a picture of your structure and we'll see if anything is obviously astray...
 

Did you used adaptive meshing? I think you should first increase your meshing. Try and post your results and give some information about your setup.
 
I'm designing a monopole using textile material and I've tried increasing the mesh size and using adaptive meshing, but still I'm getting the same results!
 

Can you show your drawing? Is adaptive meshing stopped by maximum number of iterations or is the desired accuracy reached?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top