Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
1) You must learn about how to bias an opamp. You have pin 3 at the supply voltage of 5V but the datasheet says an input of an LT1014 opamp does not work if it is higher than 3.5V when there is a 5V supply. Pin 3 should be at half the supply voltage (Texas Instruments was wrong in their text that I deleted).
2) You have its AC and DC gain at more than 4 thousand times but it must be a little more than only 4 in a Bubba oscillator.
3) The input resistance of the LT1014 opamp is too low to use a feedback resistor as high as 2.2M ohms.
4) Your value of only 470 ohms for R6 shorts the signal.
5) Also usually an oscillator in a simulation needs to be kicked with a pulse to get it going.
Here is the Bubba oscillator from Texas Instruments that is using a modern rail-to-rail input and output quad opamp that has an extremely high input resistance:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.