Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[Simulation Comparison] CST design into ADS...

Status
Not open for further replies.

kela3kela

Full Member level 4
Joined
Apr 30, 2009
Messages
190
Helped
5
Reputation
10
Reaction score
5
Trophy points
1,298
Activity points
2,498
I made a simple patch antenna in CST. Now I want to compare its results (S11) by designing it in ADS and HFSS. I'm able to import DXF files from CST into HFSS and ADS. I successfully simulated the design in HFSS but was wondering if I can simulate the DXF file in ADS (Momentum) as well?
Is it doable? Solutions??

Awaiting replies,

regardsR
 

Brother I have already imported the DXF...I need to know how to simulate it in ADS to get S-parameters..
 

I need to know how to simulate it in ADS to get S-parameters..

As for all EM tools, this isn't trivial for a beginner if you want good, accurate results.

The fastest way to learn it: Agilent offer a great 3-day training that gets you started with Momentum.

If you want to learn it on your own: In ADS, click on Help > Getting started with ADS. This shows a link to the manuals and video trainings. Another good resource to get started: **broken link removed**
 

Thankyou for the link, but I was hoping for a more rapid responce as Im just interested in comparing results of diff simulators rather learning a tool in a short time.
 

Thankyou for the link, but I was hoping for a more rapid responce as Im just interested in comparing results of diff simulators rather learning a tool in a short time.

This is the answer that I was expecting - some users don't spend the time to learn the tool, and then do some benchmarking based on misunderstanding and wrong tool use. How do you want to compare results if you don't understand how to use the tool properly? EM always gives some results - and with untrained users the result is bad and inaccurate in most cases. This applies to all EM tools, not just Momentum.
 

Indeed one should spent more time learning any tool if he is to work on it later on. But the sole purpose, the forums exist are to help others get their results quickly and efficiently. :)
Anyways, thnx for ur time and suggestions.
 

Before posting here, I had seen alot of Momentum videos but none explain the simulation running after DXF imports :)
 

Before posting here, I had seen alot of Momentum videos but none explain the simulation running after DXF imports :)

But what difference does it make? DXF import is just another way to create the layout. The Momentum part is not different. There is only one detail where you need to be careful: the layer where your DXF layout is imported. You can set the layer mapping during DXF import.

If your layout is not on the standard layers ("cond", "cond2") you need to specify your layers in the EM substrate defintion, instead of the usual cond, cond2 etc. Alternative: you can also select your layout and change the layer to the standard layers.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top