Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Not quite sure what I'm looking at there, but the misalignment between the two circles looks excessive. You must have some offset difference between layers.
ohh no no
Actually I moved the drill to make some space.
The previous hole is the circle in the back.
Basically my doubt is does there need to be any gap between drill holes and tname layered text? Will it affect my circuit in any way?
just like the error in the image I am getting a quite a lot errors of this type..
do I need to move all the drill holes and the texts to keep them away or it won't matter?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
