Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[General] How to interface fingerprint scanner R303 with PC using matlab??

Status
Not open for further replies.
S

shahpatel19

Newbie level 2
Joined
Oct 12, 2014
Messages
2
Helped
1
Reputation
2
Reaction score
1
Trophy points
3
Activity points
10
hello m new here.:roll:
i wanna know How to interface fingerprint scanner with PC using matlab? i will b grateful if u can give code also ??
m using fingerprint module r303 along with max232 module
 

Check whether the PC,which will be connected to your fingerprint scanner also supports RS232 communication mode.If it does,then find a connector for physically connecting the scanner device to the RS232 port and a driver,which you will have to install on the PC for communicating with the driver.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top