Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I just started to program EEPROM , however the OV7955 system control start with [0x0100 - 0x3043]
during program, do i need to start from 0x0000 or 0x0100??
The first lines of the final code will be initializing all the devices that are connected to the processor.Only after the devices have been initialized,the data transfer from the connected devices can be initiated.So I would say,you start from 0x0100.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.