Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Question about raw material cost for PA module in a handset

Status
Not open for further replies.
Z

zmliu

Member level 5
Joined
Mar 21, 2004
Messages
89
Helped
8
Reputation
16
Reaction score
4
Trophy points
1,288
Activity points
620
PA module

Here is an interview question:
Power amplifier modules used in handset generally consists of GaAs HBT amplifiers, CMOS controller and laminate boards. Break down the raw material cost and development cycle for each component. Use your best judgement and state the assumptions used in the estimate.

If somebody has experience with this area,please reply.Thanks.
 

Re: PA module

the reason of use the BJT as the pa of the handset is that it can carrier more current density than other device when the same volume of the device is used!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top