Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Converting 24 Volt DC to 580 volt DC 1 Amp supply

Status
Not open for further replies.
E

engineerpervez1

Member level 5
Joined
Dec 26, 2010
Messages
84
Helped
15
Reputation
30
Reaction score
14
Trophy points
1,288
Location
Lahore Pakistan
Activity points
1,841
I want to design 24 Volt DC (2 nos of 12 volt batteries in series) to 580 volt DC supply using UC3856 and IR2010S
4 nos of MOSFET in h bridge form, MOSFET should be low RDs on as 2.2 mili ohms
chips with the chopper transformer
ideas and help is required
 
Last edited:

In simple theory this sounds like what you wish to do.



Notice you cannot have more than about 1/10 ohm total resistance through all devices in the primary loop.

Of course you'll need to add control circuitry, etc.

You can replace the transistors with mosfets. You must determine which arrangement of N and P devices works best for you.
 

Thanks for your suggestion, I will use N-Channel MOSFET and probably IRF2804, 4 nos in full bridge. these are very low RDSon. operating frequency is 25 KHz.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top