Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to genrate PAD file from Eagle

Status
Not open for further replies.
E

ep.hobbyiest

Full Member level 4
Joined
Jul 24, 2014
Messages
212
Helped
1
Reputation
2
Reaction score
1
Trophy points
18
Activity points
1,487
i have done design in eagle. so i decided to to give to make pcb. This is my first time so i don't know how to genrate require files to make PCB. after contacting manufacturer he told me too give three files film.
Silk layer, Bottom layer, and pad file for single side pcb.
i have genrated Silk layer, Bottom layer but don't know how to genrate pad file.
so help me to genrate this file. from eagle.
I have attached file example as given by him.
20140926_193056.jpg
 

How are you generating the files? Doing image export?

Looking that image you have, looks like he wants the solder stop mask layer. In Eagle there are two layers, tStop e bStop. As your design is single sided, I think you'll need just the bStop layer.
 

Yes i was tried this it is comes as inverted as i want.
 

Attachments

  • PAD_File.pdf
    9.6 KB · Views: 84

anyone know this please?
tell me how to genrate pcb like posted in #1 post.
I can generate pcb like shown in #3.
is there any .ulp to run.
or something else.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top