Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I meant that when i was runing the Makefile, then The makefile's results are printed to monitor.
so the makefile that are printed error messages are just 10 of 255.
when i trying to run every time, so the error message are just 10 for each run.
Why do you want more error messages? Anyways, it is printing 10 everytime because the case ends at that point everytime..
I hope I have understood your question...
Any one error can cause a tool to print out alot of error messages. For example if you forget to add the endmodule to a verilog file you will see hundreds or thousands of error messages as it tries to compile the next module.
You should only fix the first error that is listed and then rerun the tool to see if any of the other errors have disapeared on their own.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.