Externet
Advanced Member level 2
- Joined
- Jan 29, 2004
- Messages
- 579
- Helped
- 28
- Reputation
- 58
- Reaction score
- 29
- Trophy points
- 1,308
- Location
- Mideast US
- Activity points
- 5,664
Hi.
For a motor speed control, the output mosfet usually has its gate with a pull-down resistor to source to keep it off; and the PWM square wave source is fed into the gate with usually a small value resistor in series.
If the PWM signal source has a capacitor at its output, would that ensure the Mosfet would never stay on if the PWM source fails and stays 'high' ?
Is it a common practice to feed signal into a mosfet gate trough a capacitor ? Why ?
Say pin 5 with a series capacitor in this random example borrowed from the web:
----> https://www.circuitstoday.com/wp-content/uploads/2010/01/speed-control-for-PCB-drill.png
For a motor speed control, the output mosfet usually has its gate with a pull-down resistor to source to keep it off; and the PWM square wave source is fed into the gate with usually a small value resistor in series.
If the PWM signal source has a capacitor at its output, would that ensure the Mosfet would never stay on if the PWM source fails and stays 'high' ?
Is it a common practice to feed signal into a mosfet gate trough a capacitor ? Why ?
Say pin 5 with a series capacitor in this random example borrowed from the web:
----> https://www.circuitstoday.com/wp-content/uploads/2010/01/speed-control-for-PCB-drill.png
