Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

pic 16f877a emi protection doubt

Status
Not open for further replies.

raman00084

Full Member level 6
Joined
Nov 29, 2010
Messages
360
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
3,995
i am doing a timer project in pic16f877a to control 3phase motor. to prevent emi i am using rc snubber in the motor side then using line filters in the microcontroller supply side then i am also using 5v TVS diode, more than this to prevent external emi i am covering the whole pic board with aluminium box and connecting the aluminium box to the negative supply(-) that is ground exactly telling 7805 voltage ic center pin that is pin2. my doubt is that can i cover the entire board with aluminium box and connect to 7805 center pin that is ground 0v?

i am doing correct kindly help

regards
kalyan
 

hi,
Thats the way I connect my IA amps, alloy case connected to 0V of the regulator.
E
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top