Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

am26ls32 terminating resistor value issue

Status
Not open for further replies.
R

raman00084

Full Member level 6
Joined
Nov 29, 2010
Messages
362
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
4,006
should i must use any terminating resistor in the input of am26ls32. i am having a servo drive in that the encoder outputs are as follows OA+,OA-,OB+,OB- i think differential can i use the above ic to take a single line out such as A and B alone with respect to gnd. my doubt is terminating resistor is needed? if so what is the value.



regards
kalyan

- - - Updated - - -

the distance of the wire is 3mts
 

If you are using twisted pair, a 120 ohm resistor would work. But that's without you telling us anything about your encoder outputs; what are they +/- 1,000,000 Volts?

And why would you use a differential receiver and connect it to a device with differential outputs and then NOT use the differential outputs?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top