Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Emerson Liebert NX 20 k

Status
Not open for further replies.

kikevargas

Newbie level 1
Joined
Sep 17, 2014
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
12
Hi everyone

We installed single input 208 VAC UPS in a new site that provides 220VAC 60% of the time since load is small w respect to installed capacity.

We provided isolation transformer at the input of this UPS in order to protect it from spikes, noise and so on.

Initially status indicator light amber. The LCD reports By pass is not present, but after some days, after power source was transfered to generator (through iso transformer) this led turned to red.
I suppose automatic by pass circuitry is damaged. Rectifier and inverter operate ok.
We dont understand why is it happening this since applied Voltage is within acceptable range ( is lower than 10% around nominal).
¿Does Any one has an idea about what is the fault cause since, there is another different UPS also protected by the same transformer and it didnt have reported no one alarm?

Thanks a lot

Enrique Vargas
 

Read history log.

View attachment sl-25210.pdf

Table 11 shows all event messages as they appear in the current status area of the LCD or the history log, along with a description and recommended actions, if any. For further information on the current status area and the history log, see 2.11 - UPS Status Messages.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top