Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

sourcing a specific barrel connector

Status
Not open for further replies.
D

dz32

Newbie level 4
Joined
Jul 30, 2014
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
50
Hi guys,

I have been searching for hours on this and cant seem to find a site to source a specific barrel connector for a project.

I want to integrate a foot pedal into a lotos ltp500d plasma cutter torch connection. Its a 3 pin barrel connector. I figured I would just make an inline connection through a footpedal if I could find the connectors. Attached is a picture of the dimensions as measured with digital calipers in imperial, metric and nearest fraction.

Anyone have any tips or tricks on where to source matching connectors?
Any help appreciated, thanks

WP_20140916_009.jpgWP_20140916_003.jpg
 

Hi Brad, thanks for the response.

I have been going through dozens of spec sheets. XLR, DIN, milspec and a couple more i forget the names of didnt match.

I just ordered a CNX-505 without spec sheet as a bit of a hail mary.

CNX-410b.jpg


I can risk 10 bucks. If it doesnt mate, but can handle the current, (12awg) then I will just order a second set and replace the existing connectors on/in the machine. Better to cut losses than endlessly searching the net I guess.
 

just as a quick note for anyone finding this thread through a search, these plugs are a match.

more details on the wiring here

**broken link removed**
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top