Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to assign the Layer while importing DXF ??

Status
Not open for further replies.
K

kabaleevisu

Advanced Member level 2
Joined
Apr 14, 2010
Messages
616
Helped
85
Reputation
170
Reaction score
81
Trophy points
1,308
Location
Chennai,India
Activity points
4,512
HI everyone, while importing DXF i need to assign the layer (only DXF Layer).is it possible previously i assigned Top layer and changed into DXF layer.every time it is irritating.please provide any solution to me
8573202700_1410492912.jpg
 

While I am sure that those that use the software know what software you are using, for the rest of us - perhaps you could give us a clue?

Looking at that dialogue it appears that you cannot save a configuration file to open each time, which would suggest to me that perhaps it either does not allow this or there may be a configuration file somewhere or some registry settings to keep default values.
 

HI i am using PADS 2005 software. i assign the one layer for DXF file while import DXF file it is not importing perfectly.let me explain to me
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top