Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In the second step of the PICkit troubleshooting you try to verify the VPP , however I get this error messages "short or very heavy load on VPP was detected"
I can not post schematic of the circuit.. this is a commercial board. I have use the PIC to program several or quite a few boards with this Pic.. I believe that I have place the PIC on incorrectly... just was wondering if I would have to buy a new PIC... or figure out what device is damaged because of " incorrect polaity" placement.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.