Raintree
Newbie level 6
voltage divider circuit
dear all,
i have a question here. i am building a voltage divider using two 1K resistor and using the voltage divider rule. It works well on the breadboard with 10V input and 5V output but once it is solder on the PCB board, the value becomes very small and i had to change one of the resistor values in order to get 5V.
I would like to know what happens and it there anywhere i can solve it?
Thanks a lot
raintree
dear all,
i have a question here. i am building a voltage divider using two 1K resistor and using the voltage divider rule. It works well on the breadboard with 10V input and 5V output but once it is solder on the PCB board, the value becomes very small and i had to change one of the resistor values in order to get 5V.
I would like to know what happens and it there anywhere i can solve it?
Thanks a lot
raintree