Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Op-Amp Servo loops on bread board

Status
Not open for further replies.
R

Rajesh jabade

Newbie level 3
Joined
Aug 28, 2014
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
19
Hello All,
I am trying to rig up Op-Amp servo loop circuit on bread board. Please let me know if anyone has tried it earlier.

Thanks
--Regards
RJ
 

crutschow,
Thanks for the reply. When I tried to measure offset voltage, my Aux op-amp is saturating. Can you please share any circuit which i can try on bread board. Any link which will give me detailed idea.

--Regards
RJ
 

Maybe you should first tell us what your servo circuit will be used for, what are the voltages and so on. Or at least post a schematic of the actual setup.
 

What is U5 supposed to do? You have the inputs connected with two 100 ohm resistors and no feedback so the output will saturate just due to the input offset being amplified by the open-loop op amp gain.

The second stage is an integrator with no reset circuit so that will also go to saturation due to input bias current.

So what is the complete circuit supposed to do?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top