Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

flyback power supply, capacitor between ground and isolation

Status
Not open for further replies.
M

masoudk_81

Junior Member level 3
Joined
Jan 2, 2005
Messages
28
Helped
4
Reputation
8
Reaction score
0
Trophy points
1,281
Activity points
314
isolation capacitor flyback

Hi

I have designed a 75 watt flyback power supply with 4 outputs and i have
isolated two sides of transformer with 6N136 optocoupler. i have seen in
some designs that a capacitor is placed between the ground of primary
and secondary. the reason is for attenuating common mode current. but
i have a question that does this capacitor reduces the isolation and is it
necessary for the circuit or not?

masoud
 

Re: flyback power supply, capacitor between ground and isola

This capacitor close circuit for curent wich flows through transformer parasitic capacitance. If you miss this capacitor, supply will be noisy, even PWM controller can behave abnormal. In general it must have capacitance of 1 to several nF. Upper values are limited by isolation requirements. It must be so called "class Y1"
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top