Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

74192 counter up/down

Status
Not open for further replies.

Josua

Newbie level 1
Joined
Aug 21, 2014
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
8
Hi guys. Can you help me? I'm working on a project using ic 74192 and ic 7448 and also a 7 segment display. My goal is to make it count either up or down, but it doesn't count and always display 0.
How can I send a pulse to it and make it count without using ic 555?
Thank you. :)
 

Here is an almost identical project....

Maybe you can use it for inspiration on getting yours to work.
 

74xxx is Standard power TTL which is normally floating input =logic "1" at 1.3V but for noise margin>=2V is valid and <=0.8V is a "0". Thus they will count if enabled using contact close to 0V on clock in. But best practise uses 10k-100k pull-up to5V.

4xxx , 14xxx series is original CMOS which is random on floating and for ESD reasons is never left floating.

Switches also bounce so a capacitor across switch or after switch increases RC time constant to reduce chatter voltage. If you want to initialize 1 on power up put capacitor from V+ to input, otherwise cap on input to ground with pullp R for momentarily "0" on power up .

Search google images for circuits e.g. https://www.google.ca/search?q=7419...qi=2&ved=0CAYQ_AUoAQ&biw=1024&bih=644#facrc=_
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top