Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Placing layer information and PCB dimensions in gerber files using altium designer

Status
Not open for further replies.
V

viperpaki007

Full Member level 5
Joined
Jul 2, 2008
Messages
270
Helped
11
Reputation
22
Reaction score
8
Trophy points
1,298
Location
Finland
Activity points
3,395
Hi,

I want to place layer stack information and PCB dimensions in gerber files so they can be visible on side of PCB when viewing gerber. How can i do that in altium designer.

regards
 

Create a layer called drill drawing. In this layer add an out line for your board.
To add dimn
: place/dimension/linear : and then select points and keep adding more. you can select more options other than linear.
To add layer stack : place/ layer stack table/ and place it on layer.
please note it will come as how you defined in layer stack manager.
thanks,
keyur
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top