Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Serial Communication with Hcs08

Status
Not open for further replies.
G

gopi90ms

Newbie level 6
Joined
Apr 5, 2014
Messages
12
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
90
I have been working rs232 communication with hcs08.I have selected 9600 baud rate .the problem is whenever load the program to controller and run with debugger I am getting proper value in hyper terminal.if I remove the debugger and run I get only jung character continously in hyper terminal.I dont know the reason...any one tell the solutuion.....
 

Which microcontroller are you using.?
If you would please upload the screenshot(s) of the debugger and hyper terminal in action,that would be helpful.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top