Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

HSPICE varying temperature during simulatiojn

Status
Not open for further replies.

siber222000

Newbie level 1
Joined
Jul 28, 2014
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
10
Hello everyone,

HSPICE newbie here and I just had a quick question regarding the temperature variance on netlist.

Question is basically how can you change the temperature during the simulation?

For example, at time 0ns I wish to simulate at temperature 30 Celsius, but then at time 700ns of the same simulation I wish to change that temperature to 90 Celsius! I did read some .dc analysis commands where you can sweep temperature, but I wish to do this in .tran analysis.

Also, .alter command would not work in my case because that would start a entirely new simulation.

Any replies would be very helpful,
Thank you very much!
Sincerely,
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top