Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem with routing a double layer board in P-CAD 2004

Status
Not open for further replies.
D

dkace

Full Member level 6
Joined
Jun 13, 2002
Messages
395
Helped
32
Reputation
64
Reaction score
7
Trophy points
1,298
Location
Greece
Activity points
3,562
Routing problem

I am routing a double layer board. I use P-CAD 2004. I started routing with the advanced router . First problem I met was that the line width wasn't the one I have designated in attributes. I continued routing and instead of the light green colour of the bottom layer I had traces in dark green. I continued with +5V and I had the same colour although I have given +5V to top layer.
What is wrong with this picture?
D.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top