dkace
Full Member level 6
Routing in PCAD2004
I have created a design in PCAD 2004 schematic editor and I have given the folowing attributes:
For Power lines and data lines: Width 40mills, clearence 15 mills
For other Nets: Width 10mills, clearence 9 mills.
When I try to route the PCB I don't get these attributes in the connections I deal with, although I checked the Nets attributes and are the same I edited in Schematic.
What I am doing wrong? What I have to do?
What are the best values for non uni-form routing grids for the above values?
Should I cange the width of each seperate net manualy?
Please help me on this asap,
D.
I have created a design in PCAD 2004 schematic editor and I have given the folowing attributes:
For Power lines and data lines: Width 40mills, clearence 15 mills
For other Nets: Width 10mills, clearence 9 mills.
When I try to route the PCB I don't get these attributes in the connections I deal with, although I checked the Nets attributes and are the same I edited in Schematic.
What I am doing wrong? What I have to do?
What are the best values for non uni-form routing grids for the above values?
Should I cange the width of each seperate net manualy?
Please help me on this asap,
D.