Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to simulate 4066 in multisim?

Status
Not open for further replies.

nadiahza

Newbie level 6
Joined
Nov 28, 2012
Messages
14
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,359
Hye..
I want to ask who can show me how to connect bilateral switch 4066 in multisim??

PLZZ
 

In the simplest sense, the 4066 contains 4 switches which are similar to relays.

Each switch is governed by its control pin (as you pull it high or low).
The control pins are referenced to ground inside the IC. They do not need a return path. (On the other hand a relay coil does need a return path).

Each I/O pair can carry current in either direction. In other words, input of switch A is interchangeable with output of switch A. Etc.
The 4066 is unusual in having this capability.
 

Untitled.png

Can you see my image... can you tell me whats wrong with the circuit...
 

Pin 14 of U1 and U2 should go to Vdd (+5V) and both pin 7 should go to GND.(0V). Your clock pulse should go to pin 13 of both U1 and U2 as they are identical.

Connect a oscilloscope to the 3 points as in my schematic and you can get more info on what your circuit is doing.

See my attachment in proteus.

Allen
 

Attachments

  • 4066 usage.GIF
    4066 usage.GIF
    155.9 KB · Views: 128

when you simulate this circuit..how was your graph look like..
 

The scope trace I got is attached.

Allen
 

Attachments

  • 4066 usage scope.GIF
    4066 usage scope.GIF
    125.7 KB · Views: 150

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top