Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] determine impedance at desired frequency

Status
Not open for further replies.
I

izmirm

Newbie level 3
Joined
Jun 6, 2014
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
16
Hello,

I am new in IC design. I am trying to make an amplifier using Cree CGH40010F. In datasheet, there are some load and source impedance values up to 3.5 GHz. But in my design I need the impedance value at 4 GHz to construct the impedance matching blocks. How can I find that impedance value? Which type of simulation should I do to find? (I am using AWR MWO to design the amplifier)
 

Hello again,

I solved this problem with Load-pull simulation. You can find any impedances at your desired frequency with load-pull analysis. AWR has the ability to make load-pull simulation with load-pull script.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top