Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Hbridge using IR2110 not working at 220V DC

Status
Not open for further replies.

suri007

Newbie level 5
Joined
May 3, 2013
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,360
Hi,

we are implementing a DC motor speed controller using Full H bridge and IR2110 drivers.

The circuit works good for 12V , but if we wish to control a 220V DC load the circuit is not working.

The high side drivers (S1 and S3) of 2 IR2110's are always ON, eventhough we give inputs to S1 and S4 (forward direction).

Gate resistor used is 10ohm and boot strap capacitor of 1uf/10uf is used.

Please help me solve the issue, why at higher DC voltage the circuit is not working

Regards,
Suresh

- - - Updated - - -

One more point to add, the same circuit if tested in half bridge configuration works fine at 220V DC .

I am not able to figure out the problem, please hlep

- - - Updated - - -

I am using a PWM frequency of 16kHZ

- - - Updated - - -

I am attaching the circuit please check and let me know what wrong did i do, and whthe circuit is not working for 220V DC
 

Attachments

  • MOTOR DRIVER.jpg
    MOTOR DRIVER.jpg
    104.8 KB · Views: 69

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top