Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to convert AC signal in mili volts to DC signal

Status
Not open for further replies.
A

adnansarwar2050

Member level 2
Joined
Oct 12, 2011
Messages
52
Helped
7
Reputation
14
Reaction score
7
Trophy points
1,288
Location
Islamabad
Activity points
1,589
I am using ACS712 hall effect current sensor.

https://www.allegromicro.com/~/media/Files/Datasheets/ACS712-Datasheet.ashx

It gives 66mV/A. I am using ADC0808 to read the value of AC current passing through real load. Now the problem is that ADC0808 reads the analog values but i need the peak value of current. How can I read this signal with ADC0808. Can any one please help me.
 

Hi,

Use an opamp to amplify the signal.

You say you need the peak value.
* Either your sampling frequency is high enough to catch the peak, then you can find the peak with software
* Or you need external analog circuitry to catch the peak...then convert to digital

Can you define the "peak" with timing, voltage and frequency (repeating)?

Klaus
 

If this signal sinusoidal , you may multiply by 1.41 that is peak value.
If it's not, you should use simple tracking peak detector with a OpAmp.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top