Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to design DVI interface for virtex 5 XUPv5 LX110T using EDK.

Thread starter Shriharsha
Start date May 6, 2014

Status: Not open for further replies.

May 6, 2014

#1

S

Shriharsha

Newbie level 4

Hello. I am trying to design a DVI interface (TFT controller) using EDK. . can any1 help me with this??
what are the steps??

May 7, 2014

#2

K

kaiserschmarren87

Member level 4

**broken link removed**

**broken link removed**

Status: Not open for further replies.

Similar threads

H
How to generate circuit design in ADS using SDR plateform
- Started by hanen88
- Jun 1, 2023
- Replies: 0
PLD, SPLD, GAL, CPLD, FPGA Design
H
How to translate design circuit in ADS (Agilent Design system) to MATLAB CODE
- Started by hanen88
- Jun 3, 2023
- Replies: 0
PLD, SPLD, GAL, CPLD, FPGA Design
VHDL. rewrite FOR LOOP using FOR GENERATE
- Started by 4pi
- Oct 26, 2023
- Replies: 6
PLD, SPLD, GAL, CPLD, FPGA Design
M
How to instantiate another vhd file inside testbench, where the testbench is used for opening files
- Started by metamisers
- Jan 6, 2024
- Replies: 6
PLD, SPLD, GAL, CPLD, FPGA Design
K
explanation of how to translate C code into verilog
- Started by keikaku
- Mar 5, 2024
- Replies: 10
PLD, SPLD, GAL, CPLD, FPGA Design

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.

Accept Learn more…

Top