Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] What is the proper distance between antenna elements for MIMO?

Status
Not open for further replies.
E

eldamar

Newbie level 5
Joined
Apr 24, 2014
Messages
10
Helped
2
Reputation
4
Reaction score
2
Trophy points
3
Activity points
68
Hi, everyone. I am designing dual band dual element MIMO antenna for WLAN operations for my thesis.
I got stuck on one thing. How can we choose proper distance between antenna elements for designing MIMO antenna in order to obtain high isolation and low mutual coupling? I searched the literature and I saw, almost every design the distance was chosen as 10mm but I don't know why. Is there any formula for calculation of the proper distance?
 

eldamar said:
Hi, everyone. I am designing dual band dual element MIMO antenna for WLAN operations for my thesis.
I got stuck on one thing. How can we choose proper distance between antenna elements for designing MIMO antenna in order to obtain high isolation and low mutual coupling? I searched the literature and I saw, almost every design the distance was chosen as 10mm but I don't know why. Is there any formula for calculation of the proper distance?
Click to expand...

To my knowledge, a MIMO system should use wave paths that are "statistically independent". This can mean that a good isolation between antennas should be used.
On the other hand, a constant "crosstalk" is not an issue in statistics. So try to use "some" degree of isolation, say 10...20 dB. If you cannot achieve it by separation, then use grounded shields to increase isolation.
Try to see how others did it, and if the isolation caused the system a problem.

- - - Updated - - -

Elements close to each other form an "array", and a specific radiation pattern results from it. Usually array directivity increases.
 
Thanks for your advice, I will try that :)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top