Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Can communication problem.....

Status
Not open for further replies.
jaga123

jaga123

Member level 1
Joined
May 16, 2011
Messages
32
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,288
Location
india
Activity points
1,533

i an working on a can project using mcp2515 as can controller.
If i have get a bit error , or stuff error in bus than how my controller will detect that is an error and which type ?
( i wanna to know how controller behave when get an error an how could i know about error...)

thank u in adv....

 

jaga123 said:

i an working on a can project using mcp2515 as can controller.
If i have get a bit error , or stuff error in bus than how my controller will detect that is an error and which type ?
( i wanna to know how controller behave when get an error an how could i know about error...)

thank u in adv....
Click to expand...

if you go to the Microchip MCP2515 pictail plus page
https://www.microchip.com/Developmenttools/ProductDetails.aspx?PartNO=MCP2515DM-PTPLS

and under Package Contents download 'MCP2515 Pictal Plus daughter board firmware'
https://ww1.microchip.com/downloads/en/DeviceDoc/00194R1_ Firmware.zip
unzip it and you will find the CAN_spi_demo project with the CAN software
 
  • Like
Reactions: jaga123

    jaga123

    jaga123

    Points: 2
    Helpful Answer Positive Rating
thank u sir
but can i check error in programing .. by using mcp2515 resister... without analyzer...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top