Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
i'm working on wireless comunication between pic16f877a and pc ..i use module xbee ..so one xbee with pic16f and one xbee connected to the pc . i make my circuit isis and i want to simulate it my question is : is that right to use compim in my circuit :
Here is only one problem.
don't connect virtual terminal Tx pin to controller tx.
use one more virtual terminal to see what is tx of controller.
like this
here is sample of hyper terminal example.
connect jumper at pin2 and pin3 of serial port and type something in virtual terminal .
you will found Eco characters in virtual terminal.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.