Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

a 4-way Wilkinson power divider with two sections

Status
Not open for further replies.

Tomsin yin

Banned
Joined
Mar 6, 2014
Messages
61
Helped
5
Reputation
10
Reaction score
5
Trophy points
8
Activity points
0
hi guys
now am designing a Wilkinson power divider with two sections,first i designed a simple one-section and got a good simulation results,but when i added a section,obtained a bad results.also my three isolation resistors is 100ohm(if it is not wrong),then i don't know how to calculate the resistor(→two sevtions quarter wave length),so can anybody help me how to do it or give me some link about it .my design and simulation is in ADS2009.my index as folloiws:
1)ferqucncy 2-3Ghz. 2)return loss is less then -20db.3)mutual isolation is less then -20db. 4)VSWR of input and output is less then 1.5(of course my oputput is less then 1.1 and i hope my input is 1.3 best altuough its 1.5 now)
thnx in advance.
 

In the image attached can see an n-port Wilkinson and the equations for the resistor and line impedance values, for various input/output port impedances.
Check how the resistors are connected one to each other.

 

hi vfone
thnx for ur help,but the picture u uploded is only one section and i know it whih the equation Z0=squareZ1*Z2,now my question is that i don't know how to calculate line impedance values with two sections.and i had read the book "Microwave and RF Wireless Systems"by David M.Pozar,in the section 5 i found the table 5.2,am noy completely sure if this table can be used to design Wilkinson power divider.ty in advance.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top