Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

lvs error for resistor

Status
Not open for further replies.

vashistha

Junior Member level 3
Joined
Jul 9, 2013
Messages
30
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,458
I have to make a layout of 200k resistor so i connected 20 resistors in series,10k each. But when i done lvs it will give a property error.
PROPERTY ERRORS
DISC# LAYOUT SOURCE ERROR
1 0(1.055,0.705) r18 R
m: 1 m: ? (reduced instance)
Why so?
 

If it is an Assura error, check if You have switch sthing like SBAR_FEATURE. In some pdks resistors with multiple bars are "strangely" treated.
 

i am using calibre

Marking layer missing?

Perhaps the proper instructions for series (and parallel) resistors extraction and comparison are missing in your Calibre PEX/LVS rules' set? Check it!

Work-around:

1. use 20 series resistors in your schematic

or - if not enough space there -

2. create a sub-cell for these 20 series-connected resistors, i.e. a schematic, symbol and lvs symbol for it, and instance the symbol in the original schematic.
 

i am using unsalicided pplus resistor, it has three terminals (plus minus sub). How i make the sub terminal in layout.Is sub terminal connected to ground
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top