Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[General] Thermal Printer( Adafruit ) interface with Microcontroller

Status
Not open for further replies.
S

Sanath Rai

Newbie level 1
Joined
Mar 28, 2014
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
6
Hello,

I am using Adafruit Thermal Printer.i need to interface(serial) this thermal printer with my Micro controller(Nuvoton-NUC121 series).

Can i do it using UART in my controller and also do i need any printer specific drivers to do it .i will use UART -RS232 communication in my board.

Any help will be appreciated,
Regards,
Sanath Rai :smile:
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top