Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to shift the pulses in labview?

Status
Not open for further replies.
M

maheshwaran

Newbie level 6
Joined
Feb 26, 2014
Messages
12
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
64
Hello sir,
I was generated the pwm pulses in labview. But I need to delaying the pulses while giving to the inverter for triggering the igbt. Please help how to shift the pulses in labview? Is there any blocks are available for shifting the high frequency pulses(2kHz)?
 

Are you working with some HW or this is just a simulation?
 

I need to give all the pulses to the ir2112 driver with help of Daq card PCIe-6321. Please suggest some idea to shift the pulses otherwise two MOSFETs are dead shorted.
 

I hope it is for 1ph application. 2 half bride drive will be there. so u need 2 or 4 output.
How u made it Labview? is case strcuture inside a while loop?
post ur code. so that we can see & correct it.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top