Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help Proteus Package

Status
Not open for further replies.
brian25

brian25

Member level 2
Joined
Feb 18, 2013
Messages
52
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Activity points
1,601
i want to make new device in proteus but i don't know when to use the electrical types configuration
(passive, input, output, pullup etc..)

j_zps609e6679.jpg



example if i want to make device Q4004l4(triac)....... where should be the passive, input and output pin here?

5194574_zps7cf79a07.jpg


thanks
 

You need to write code to create simulation model and compile it to create a .dll for your model. To create schematic (non sim) model you can use the method you have shown. For schematic model it doesn't matter what electrical type you choose for pins. It is required only for sim model.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top