Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Multiple Microphone Driver Circuit

Status
Not open for further replies.
D

djnik1362

Full Member level 2
Joined
Aug 9, 2010
Messages
136
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,298
Location
IRAN
Activity points
2,374
Hi
I am using a Microphone Preamplifier circuit for a single microphone.
I can use "standard condenser" or "electret condenser" microphone.

I need to use 6 microphones with that circuit by parallelizing these 6 microphones
and connecting these microphones to the Preamplifier inputs. (Preamplifier has inputs for one microphone)

I am using 6 microphones because i need to catch sound from a closed volume .
i put each of these microphones into the volume to cover whole volume.

Is this is a good idea or i must use another circuit ?

Thanks for your support.
 

I made a boardroom telephone conferencing system using 8 electret mics connected in parallel. It worked pretty well but picked up a fair amount of background sounds and echoes. The Jfet inside each electret mic is normally powered through a 10k resistor so the resistor I used had a resistance low enough (1.2k) to power all the mics.

Another boardroom telephone conferencing system I built used many electret mics and a mic mixer that switched on only the one mic that had the highest sound level and it worked very well.
 
Audioguru said:
I made a boardroom telephone conferencing system using 8 electret mics connected in parallel. It worked pretty well but picked up a fair amount of background sounds and echoes. The Jfet inside each electret mic is normally powered through a 10k resistor so the resistor I used had a resistance low enough (1.2k) to power all the mics.

Another boardroom telephone conferencing system I built used many electret mics and a mic mixer that switched on only the one mic that had the highest sound level and it worked very well.
Click to expand...

Thanks . Very Useful .
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top