Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PWM capture registers lpc24xx

Status
Not open for further replies.
S

sns22

Member level 2
Joined
Jan 15, 2011
Messages
46
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
Spain
Activity points
1,708
Hi.

I am not able to understand the functionality of some PWM registers to be used in capture mode.

I have been trying to interface the PWM based max6672 sensor with the PWM capture pin. I want to read the both the low time and high time of the PWM pulse. I am recieving an interrupt when the PWm input is received. But some how I am not able to calculate the rise and fall time correctly. I need this info to calculate the temperature of the sensor.

PCLKSEL0_bit.PCLK_PWM0 = 1; Can this be also used to set the pclk divisor for the capture input or is it only for PWM funactionality.

I want to use this PCAP0.0 pin as a counter. In the datasheet we have to set the 
Code C - [expand]
1
2

PWM0CTCR_bit.CM = 0; 
PWM0CTCR_bit.CIS = 1; to enable the rising edge counter mode one needs to set this pin.

And if the counter mode is enabled the pins @CCR as must be 000 as set. ref UM10237 datasheet pg 643

Code C - [expand]
1
2
3

PWM0CCR_bit.CAP0RE = 0; //capture of rising edge
PWM0CCR_bit.CAP0FE = 0; //disable falling edge capture 
PWM0CCR_bit.CAP0INT = 0; //enable interrupt rising edge

But when I do this setting i am not receiving an interrupt from the sensor.

But if I set the PCAP0.0 pin as a timer 
Code C - [expand]
1
2
3
4
5
6

PWM0CTCR_bit.CM = 0; 
PWM0CTCR_bit.CIS = 0; and CCR for rising edge 0x5 and falling edge 0x6
 
PWM0CCR_bit.CAP0RE = 1; //capture of rising edge
PWM0CCR_bit.CAP0FE = 0; //disable falling edge capture 
PWM0CCR_bit.CAP0INT = 1; //enable interrupt rising edge 0x5

later I change in the interrupt to 0x6 for falling edge I am able to detect the interrupt but the counter doesnt have the correct values.

Is there something wrong in my understanding of the code?Can someone clear this for me?

Regards
Sns
 
Last edited by a moderator:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top