Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Question about 3 Phase inverter

Status
Not open for further replies.
X

xyz9915

Member level 4
Joined
May 14, 2007
Messages
74
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Location
Pakistan
Activity points
1,817
Hello,
I want to make three phase inverter. In a 3 phase 60Hz power supply, each phase angle remains 120 degree out of phase with other. I want to use micro-controller for pulse generation. My question is how much delay (in m/sec or micro seconds) may be added to keep each phase 120 degree out of phase.
 

Re: Question about 3 Phase

20mS/3 for 50Hz
16,66mS /3 for 60Hz
 
Re: Question about 3 Phase

Instead of a delay you should think of clock generator that is divided down to produce multiple phase shifted outputs. It would also work for a frequency variable inverter.
 

Re: Question about 3 Phase

Thanks to all for the help

Dear FvM can you please explain your idea in detail?
 

Re: Question about 3 Phase

E.g. if you want to generate 60 Hz square waves as a three phase system, start with a 360 Hz clock.
 

Re: Question about 3 Phase

Dear FvM
Please elaborate because i am still confused how to get 3 phase waveform in this way?
 

Re: Question about 3 Phase

FvM said:
E.g. if you want to generate 60 Hz square waves as a three phase system, start with a 360 Hz clock.
Click to expand...

xyz9915 said:
Dear FvM
Please elaborate because i am still confused how to get 3 phase waveform in this way?
Click to expand...

Each cycle of a 1-phase 60Hz waveform is subdivided into 2 half-cycles, one positive, another negative. It means that a clock required to switch between half-cycles is twice ( 2x60Hz ).

Working with 3-phase square wave generation, a shift of 1/3 period is required for each phase. It means that above 120Hz clock must be sized to triple ( 360Hz ).



+++
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top