Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[51] How to program AT89c51?

Status
Not open for further replies.
N

Narendra1190

Member level 2
Joined
Jan 23, 2014
Messages
44
Helped
6
Reputation
12
Reaction score
6
Trophy points
1,288
Activity points
1,666
hi,
I bought an AT89c51 dev. board from below link.

**broken link removed**

I read some forum about interfacing RS232 with MCU for serial communication.I'm having USB to serial converter(DB9) which i used to connect my laptop and Dev. board.
I dont know how to burn hex file into AT89c51. Is it possible to load program through RS232?
 

Have you got any supporting software with the development board???
 

no.sir, which programmer software i have to use to burn hex file on AT89c51 n how i can do tht?
 

Every hardware has its own supported software and without it you can't do anything with the hardware....for example i am using the genius g540 programmer and it has a software in which i can load a hex and can test ICs...

- - - Updated - - -

You can search the software for your development board on internet
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top