Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Boost PFC Measurements?

Status
Not open for further replies.
A

abhinand rd

Member level 1
Joined
Jul 15, 2011
Messages
32
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
bangalore
Activity points
1,516
Hello People,
I am having a circuit that has boost based PFC in it(400V,5A).
i need to measure the power factor and total harmonic distortion.
Is it possible just with measurement of voltage and currents waveforms?
Is so, can anyone tell me the procedure how to do it?

Thanks & Regards
 

To measure the power factor, you need to measure the angle between the current and the voltage. For total harmonic distortion, you need a "distortion meter" or a very good notch filter to get rid off the 50 (60)HZ component.
Frank
 

Hey Frank,
Thanks for ur reply.
Is it sufficient to measure phase angle between current and voltage to calculate power factor? what if the phase angle is zero but current waveform is distorted?
And also, can u pls elaborate on how to measure THD using notch filter technique?
 

Is it sufficient to measure phase angle between current and voltage to calculate power factor? what if the phase angle is zero but current waveform is distorted?
Click to expand...
For non-sinoidal curents, power factor has to be calculated as product of displacement and distortion power factor. https://en.wikipedia.org/wiki/Power_factor

Technically, PF will be usually determined as the ratio of in-phase fundamental current and total RMS current.

The harmonic currents, which have different limit values in power quality standards are mostly measured by DFT methods. See IEC1000-3-2 or EN61000-3-2 for reference.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top