Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
If the LED is the source emitting coded light/UV, you can use a Light sensor to detect the transmitted light and then convert them to digital signals, then do the rest of the processng.
You can use the same signal which drive the LED to input to your glue-logic. So when the LED glows, you will get the same signal as input to your logic.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.