Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Encounter RTL Compiler

Status
Not open for further replies.
A

aceyhan

Newbie level 5
Joined
Jun 22, 2010
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,358
I am using Encounter RTL Compiler Version 10.1.

I am getting the following warning message as a result of using the command (report ple). This warning message is about the tool dropping certain metal levels and it looks like the following:

** = 'M1' is dropped because its Resistance/Length (value_of_resistance_here) is too large (threshold is 50).


I would like to find out how to change this threshold so that the values that I enter in my LEF file are not changed with the threshold value which is somehow set to 50. I went over the command reference and attribute reference manuals, but could not find out how to solve this issue yet.

Any help is appreciated.

Thanks!
 

I think your problem is caused by high fanout nets.
 

Hi RCircuit, for info, the message is just based on library data analysis done by the tool, which no design is yet read.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top