Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

making down counter become one shot counter

Status
Not open for further replies.
Z

zahiy

Newbie level 3
Joined
Mar 24, 2009
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,298
Hello,

is there any way I can configure CD40103BE (presettable down counter) to stop after Carry Out? like one shot counter. After a trigger it needs to count the Jam, when it gets to 0 it gives me Carry Out signal and STOPS! I dont want it to count again.


any help?

thank you.
 

Although not properly recommended due to don´t employ a synchronous approach, you could try firstly connecting a XOR 2-port gate.




+++
 

andre_teprom said:
Although not properly recommended due to don´t employ a synchronous approach, you could try firstly connecting a XOR 2-port gate.




+++
Click to expand...


thank you for your help, can you be more specific, where to connect the XOR gate?
 

Try this way:
  • Connect 1st gate input to external measured signal
  • Connect 2nd gate input to counter output
  • Connect gate output to counter input

Correction: Not a XOR gate, but a NOR.

+++
 

Thank you, i will try it tomorrow and post the result
 

Solution purposed at post #4 by FvM is quite better, due do not require external gates.


+++
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top