Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Single phase induction motor winding calculation needed

Status
Not open for further replies.

ID10T

Newbie level 1
Joined
Dec 9, 2013
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
10
Hi Folks.
I'm a complete beginner so please be gentle.
I'm trying to rewind a 240v, 440w, single phase induction motor. My problem is that in taking apart the windings (which were heavily varnished and fairly fried) the coils became very difficult to count so I've ended up with some discrepancies even after several counts.
Starter coils: 45, 44, 46, 45, 47, 48, 42, 41 no of turns with .35mm wire
Main Coils: 44, 66,107, 106, 107, 107, 65, 45 no of turns with .7mm wire
I'm presuming that the main coils would be bumped up to the higher number so: 45, 66,107, 107, 107, 107, 66, 45 but I'm lost regarding what to do about the starter coils. Is there a simple way to calculate no of turns?
Stator plates are 35mm thick with a hole diameter of 61mm and 24 slots.

Any help would be much appreciated.

Thanks.
 
Last edited:

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top