Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Manufacturing LEDs that are in a certain Vf group means they will be dimmer?

Status
Not open for further replies.
T

treez

Guest
In the excellent Osram application note, titled 'LED diagnosis in automotive applications', page 1 states that because LEDs are optimized for brightness, the other electrical parameters such as Vf, tend to vary significantly when compared to normal silicon diodes.
Does this mean that when you manufacture LEDs to be in a certain tight Vf range, you are sacrificing light output of those LEDs? (in other words, producing LEDs in a tight voltage group means that they will be dimmer, because too much emphasis has been put on meeting the Vf spec?)

"LED diagnosis in automotive applications" ..Application Note
**broken link removed**
 

Illumination LEDs are generally current-controlled and the
Vf is almost a "throwaway" parameter - unless you intend
to match parallel strings, in which case you care about
something the manufacturer doesn't, so much - hence
binning rather than process control.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top