Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have design a wilkinson power divider in ADS2011. i am getting correct result for S parameters.
but the problem is with layout. I am not getting correct layout. please look at my layout and tell me what
is the problem.
no i have not connected the left side with the right side. it is generated by the ads. If i remove the resister then it gives correct layout,but without resistor it is not going to work please help me.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.